Configuration Example For Connecting A Lan To The Internet Through An Adsl Modem - HPE FlexNetwork MSR series Configuration Manual

[RouterB] interface dialer 1
[RouterB-Dialer1] dialer bundle enable
# Associate Dialer 1 with dialer access group 1.
[RouterB-Dialer1] dialer-group 1
[RouterB-Dialer1] quit
# Configure Dialer 1 to obtain an IP address through PPP negotiation.
[RouterB-Dialer1] ip address ppp-negotiate
# Configure a PPPoE session that corresponds to dialer bundle 1 (dialer bundle 1 corresponds
to Dialer 1).
[RouterB] interface gigabitethernet 1/0/1
[RouterB-GigabitEthernet1/0/1] pppoe-client dial-bundle-number 1
[RouterB-GigabitEthernet1/0/1] quit
# Configure the PPPoE session to operate in diagnostic mode, and set the diagnostic interval to
200 seconds.
[RouterB] interface dialer 1
[RouterB-Dialer1] dialer diagnose interval 200
# Set the DDR auto-dial interval to 10 seconds.
[RouterB-Dialer1] dialer timer autodial 10
Verifying the configuration
# Display summary information about the PPPoE session established between Router B and Router
A (PPPoE server).
[RouterB-Dialer1] display pppoe-client session summary
Bundle ID
1 1
Configuration example for connecting a LAN to the Internet
through an ADSL modem
Network requirements
As shown in
•
Router A provides Internet access for Host A, Host B, and Host C. It connects to the DSLAM
through an ADSL modem and a permanent PPPoE session.
•
The username and password of the ADSL account are user1 and 123456.
•
Router A operates as a PPPoE client, and it allows the hosts in the LAN to access the Internet
without PPPoE client software.
•
Router B operates as the PPPoE server. It performs RADIUS authentication and accounting.
Interface VA
GE1/0/1 VA0
Figure 19:
RemoteMAC LocalMAC
00e0-1400-4300 00e0-1500-4100 SESSION
63
State