HPE FlexNetwork MSR series Configuration Manual page 23

Step
1. Enter system view.
2. Enter interface view.
3. Enable IP segment match.
Configuring DNS server IP address negotiation
Configure DNS server settings depending on the role of your device in PPP negotiation.
•
Configuring the local end as the client
During PPP negotiation, the server will assign a DNS server IP address only for a client
configured with the ppp ipcp dns request command. For some special devices to forcibly
assign DNS server IP addresses to clients that do not initiate requests, configure the ppp ipcp
dns admit-any command on these devices.
To configure the local end as the client:
Step
1. Enter system view.
2. Enter interface view.
3. Enable the device to request
the peer for a DNS server IP
address.
4. Configure
accept the DNS server IP
addresses assigned by the
peer even though it does not
request the peer for the DNS
server IP addresses.
•
Configuring the local end as the server
Step
1. Enter system view.
2. Enter interface view.
3. Specify the primary and
secondary DNS server IP
addresses to be allocated to
the peer in PPP negotiation.
Command
system-view
interface
interface-number
ppp ipcp remote-address match
Command
system-view
interface
interface-number
ppp ipcp dns request
the device to
ppp ipcp dns admit-any
Command
system-view
interface
interface-number
ppp
primary-dns-address
[ secondary-dns-address ]
interface-type
interface-type
interface-type
ipcp dns
14
Remarks
N/A
N/A
By default, this feature
disabled.
Remarks
N/A
N/A
By default, a client does not
request its peer for a DNS server
IP address.
By default, a device does not
accept the DNS server
addresses assigned by the peer if
it does not request the peer for
the DNS server IP addresses.
This command is not necessary if
the ppp ipcp dns request
command is configured.
Remarks
N/A
N/A
By default, a device does not
allocate DNS server IP addresses
to its peer if the peer does not
request them.
is
IP