HPE FlexNetwork MSR series Configuration Manual page 20

Step
Configure the server to assign an IP address to a client by using the following methods:
•
Method 1: Specify an IP address for the client on the server interface.
•
Method 2: Specify a PPP or DHCP address pool on the server interface.
•
Method 3: Associate a PPP or DHCP address pool with an ISP domain.
For clients requiring no authentication, you can use either method 1 or method 2, but not both.
For clients requiring authentication, you can use one or more of the three methods, but cannot use
method 1 and method 2 at the same time. When multiple methods are configured, method 3 takes
precedence over method 1 or method 2.
PPP supports IP address assignment from a PPP or DHCP address pool. If you use a pool name that
identifies both a PPP address pool and a DHCP address pool, the system uses the PPP address
pool.
To configure the device as the server (Method 1):
Step
1. Enter system view.
2. Enter interface view.
3. Configure the
assign an IP address to the
peer.
4. Configure an IP address for the
interface.
To configure the device as the server (Method 2: Specify a PPP address pool):
Step
1. Enter system view.
2. Configure a PPP address pool.
3. (Optional.) Configure
gateway address for the PPP
address pool.
4. (Optional.) Configure a PPP
address pool route.
5. Enter interface view.
6. Configure the
assign an IP address from the
configured PPP address pool
to the peer.
Command
Command
system-view
interface
interface-number
interface to
remote address ip-address
ip address ip-address
Command
system-view
ip
start-ip-address [ end-ip-address ]
[ group group-name ]
a
ip pool
ip-address
vpn-instance-name ]
ppp ip-pool route ip-address
{ mask-length
[
vpn-instance-name ]
interface
interface-number
interface to
remote address pool pool-name
11
interface-type
pool pool-name
gateway
pool-name
[ vpn-instance
| mask }
vpn-instance
interface-type
Remarks
about the ip address command,
see Layer 3—IP
Command Reference.
Remarks
N/A
N/A
By default, an interface does
not assign an IP address to the
peer.
By default, no IP address is
configured on an interface.
Remarks
N/A
By default, no PPP address
pool is configured.
By default, the PPP address
pool is not configured with a
gateway address.
By default, no PPP address
pool route exists.
The destination network of the
PPP address pool route must
include the PPP address pool.
N/A
By default, an interface does
not assign an IP address to the
peer.
Services