Setting The Answer Timeout Timer - HPE FlexNetwork MSR series Configuration Manual

Step
2. Enter user line
view.
3. Enable
modem
answer incoming
calls,
outgoing calls, or
both.

Setting the answer timeout timer

The answer timeout timer sets the amount of time that the modem will wait for a call to establish.
When the timer expires, the modem disconnects the call.
•
If the modem is on the calling party side, the timer starts when the modem starts to dial.
•
If the modem is on the called party side, the timer starts when the modem goes off hook.
To set the answer timeout timer on user lines:
Step
1. Enter
view.
2. Enter user line
view.
3. Set the answer
timeout timer.
Command
line { first-num1 [ last-num1 ] |
aux tty
{ |
[ last-num2 ] }
the
to
modem enable { both | call-in |
initiate
call-out }
Command
system
system-view
line { first-num1 [ last-num1 ] |
{ aux | tty
[ last-num2 ] }
modem answer-timer time
Remarks
This command is available on the following
user lines:
•
TTY lines for the following interfaces:



} first-num2
•
AUX line
This command is not available on the console
or VTY lines.
To display the user line for an interface, use
the display line command.
By default, a modem is disabled from
answering incoming calls and initiating
outgoing calls.
Remarks
N/A
This command is available on the following
user lines:
•
TTY lines for the following interfaces:



} first-num2
•
AUX line
This command is not available on the console
or VTY lines.
To display the user line for an interface, use
the display line command.
The default timer value is 60 seconds.
148
AM interface
Asynchronous serial interface
Asynchronous/synchronous
interface operating in asynchronous
mode
AM interface
Asynchronous serial interface
Asynchronous/synchronous
interface operating in asynchronous
mode
serial
serial