Configuring The Polling Feature - HPE FlexNetwork MSR series Configuration Manual

Step
To configure MS-CHAP or MS-CHAP-V2 authentication when no authenticator name is configured:
Step
1. Enter system view.
2. Enter interface view.
3. Configure
authenticator
authenticate
peer
MS-CHAP
MS-CHAP-V2.
4. Configure local or
remote
authentication.

Configuring the polling feature

The polling feature checks PPP link state.
On an interface that uses PPP encapsulation, the link layer sends keepalives at keepalive intervals
to detect the availability of the peer. If the interface fails to receive keepalives when the keepalive
retry limit is reached, it tears down the link and reports a link layer down event.
To set the keepalive retry limit, use the timer-hold retry command.
On a slow link, increase the keepalive interval to prevent false shutdown of the interface. This
situation might occur when keepalives are delayed because a large packet is being transmitted on
the link.
The keepalive interval must be smaller than the negotiation timeout time.
To disable sending of keepalives, set the keepalive interval to 0.
To configure the polling feature:
Step
1. Enter system view.
2. Enter interface view.
Command
For remote AAA authentication,
the username and password of
the peer must be configured on
the remote AAA server.
For more information about AAA
authentication,
Configuration Guide.
Command
system-view
interface
interface-number
the
to
ppp authentication-mode { ms-chap |
the
ms-chap-v2 } [ [ call-in ] domain
by using
isp-name ]
or
For local
username and password of the peer
must be configured on the authenticator.
For remote AAA authentication, the
username and password of the peer
AAA
must be configured on the remote AAA
server.
For more
authentication,
Configuration Guide.
see Security
interface-type
AAA authentication,
information about
see Security
Command
system-view
interface interface-type
interface-number
9
Remarks
configured on the peer.
Remarks
N/A
N/A
By default, PPP authentication is
disabled.
the
The username and password of the
peer configured
authenticator or remote AAA server
must be the same as those
configured on the peer.
AAA
Remarks
N/A
N/A
on the