HPE FlexNetwork MSR series Configuration Manual page 219

# Configure PAP authentication on the interface.
[RouterB-Async2/4/0] ppp authentication-mode pap
[RouterB-Async2/4/0] ppp pap local-user userb password simple userb
[RouterB-Async2/4/0] quit
# Repeat the steps to configure physical and link layer parameters for interfaces Async 2/4/1
through Async 2/4/7. (Details not shown.)
# Configure user lines TTY 1 through TTY 7 for interfaces Async 2/4/0 through Async 2/4/7, and
enable modem dial-in and dial-out on them.
[RouterB] line tty1
[RouterB-line-tty1] modem enable both
[RouterB-line-tty1] quit
[RouterB] line tty2
[RouterB-line-tty2] modem enable both
...
[RouterB-line-tty8] quit
# Configure an IP address pool for address assignment.
[RouterB] domain system
[RouterB-isp-system] ip pool 1 100.1.1.1 100.1.1.16
[RouterB-isp-system] quit
3. Configure the PC:
a. Place the modem connected to PC in auto answer mode.
b. Right-click the My Network Places icon and select the Properties option from the menu
that appears.
The Network and Dial-up Connections window appears.
c. Right-click the Make New Connection icon and select the New Connection...option from
the menu that appears.
The Network Connection Wizard window appears.
d. Click Next.
The Network Connection Type dialog box appears.
e. Select the Dial-up to the Internet option, and click Next.
The Internet Connection Wizard dialog appears.
f. Select I want to set up my Internet connection manually, or I want to connect through
a local area network. Click Next.
The Setting up your Internet connection dialog box appears.
g. Select the I connect through a phone line and a modem option. Click Next.
h. Enter the phone number for dialing to the callback server. Click Next.
i. Enter the username user16 and password user16 that you want to use for PPP
authentication when connecting to the server. Click Next.
j. Assign a name to your new connection and follow the instruction to complete the connection
establishment.
k. Open the Network and Dial-up Connections window, right-click the connection you just
created, and select the Properties option in the menu that appears.
The properties setting dialog box appears.
l. Select the Networking tab. In the Type of dial-up server I am calling list, select PPP:
Windows 95/98/NT4/2000, Internet. Click Settings, select the Enable LCP extensions
box, clear the Enable software compression box, clear the Negotiate multi-link for
single link connections box, and click OK.
210