HPE FlexNetwork MSR series Configuration Manual page 120

Step
4. Configure the CONNECT
ACK processing method.
5. (Optional.) Exclude the HLC
information element from
the outgoing
message.
6. (Optional.) Exclude the LLC
information element from
the outgoing
message.
7. (Optional.) Exclude
ignore the
complete indication for call
setup.
8. Set the value of an ISDN L3
timer.
9. Set the number type and
numbering
identification for
numbers or called numbers.
10. Enable overlap sending for
called numbers.
Command
isdn ignore
[ incoming | outgoing ]
isdn ignore hlc
SETUP
isdn ignore llc
SETUP
or
sending
isdn ignore sending-complete
[ incoming | outgoing ]
isdn l3-timer
time-interval
isdn
plan
number-property
calling
called ] [ in | out ]
isdn overlap-sending [ digits ]
111
Remarks
interfaces and 1 byte for the BRI
interface.
The call reference identifies a call
registration or cancellation request
on the local interface.
By default:
•
connect-ack
•
By default, all ISDN protocols except
5ESS and QSIG include the HLC
information element in the SETUP
message.
The high layer compatibility (HLC)
element
compatibility check information for
the called party. The called party will
reject the call setup request if it
detects an incompatibility.
By default, all ISDN protocols except
5ESS and QSIG include the LLC
information element in the SETUP
message.
The lower layer compatibility (LLC)
element
compatibility check information for
the called party. The called party will
reject the call setup request if it
detects an incompatibility.
By default:
•
•
The default ISDN L3 timer values
timer-name vary by ISDN protocol. For the
default timer values, use the display
isdn parameters command.
By default, the system automatically
number-property
selects
[ calling |
numbering plan appropriate to the
upper-layer service.
By default, en-bloc sending
enabled for called numbers. In the
SETUP message, ISDN includes all
information required by the network
to process the call.
If overlap sending is enabled, called
After sending a CONNECT
request, ISDN waits for a
CONNECT ACK before
changes to the ACTIVE state
for traffic transmission.
After receiving a CONNECT
request, ISDN sends
CONNECT ACK and changes
to the ACTIVE state.
provides high
provides low
The device checks incoming
SETUP messages for
sending complete indication.
The device includes a sending
complete indication in outgoing
SETUP messages.
a number type
it
a
layer
layer
the
and
is