Atm Configuration Examples; Ipoa Configuration Example - HPE FlexNetwork MSR series Configuration Manual

Task
information about PVCs
or PVC groups.
Display VE
information.
Clear PVC statistics.
Clear VE
statistics.

ATM configuration examples

IPoA configuration example

Network requirements
As shown in
intercommunication.
The IP addresses of the ATM interfaces of the three routers are 202.38.160.1/24, 202.38.160.2/24,
and 202.38.160.3/24.
In the ATM network:
•
The VPIs/VCIs of Router A are 0/40 and 0/41, connected to Router B and Router C,
respectively.
•
The VPIs/VCs of Router B are 0/50 and 0/51, connected to Router A and Router C, respectively.
•
The VPIs/VCIs of Router C are 0/60 and 0/61, connected to Router A and Router B,
respectively.
All the PVCs on ATM interfaces of the three routers operate in IPoA application mode.
Figure 44 Network diagram
Router A
ATM2/4/0
202.38.160.1/24
VPI/VCI:
To Router B:0/40
To Router C:0/41
Configuration procedure
1. Configure Router A:
# Enter the view of interface ATM 2/4/0 and configure an IP address for it.
<RouterA> system-view
Command
interface-number.subnumber } [ pvc { pvc-name | vpi/vci } | pvc-group
group-number ] ]
display interface [ virtual-ethernet [ interface-number ] ] [ brief [ description |
interface
down ] ]
reset atm
interface-number.subnumber } ]
interface reset counters
interface-number.subnumber ] ]
Figure 44, Router A, B, and C are connected to the ATM network for
ATM2/4/0
202.38.160.2/24
VPI/VCI:
To Router A:0/50
To Router C:0/51
ATM network
ATM2/4/0
202.38.160.3/24
VPI/VCI:
To Router A:0/60
To Router B:0/61
interface [ interface-type
interface [ virtual-ethernet
Router B
Router C
138
{ interface-number
[ interface-number
|
|