Atm Configuration Task List; Configuring An Atm Interface; Configuring A Pvc - HPE FlexNetwork MSR series Configuration Manual

comes up when the specified number of successive OAM F5 Loopback cells are received. The
PVC goes down when the specified number of successive OAM F5 Loopback cells are not
received.
•
OAM F5 end-to-end—Sends OAM F5 end-to-end cells through the specified PVC on the
specified ATM interface. If no response is received within the specified period, the link might be
disconnected or congested.

ATM configuration task list

Tasks at a glance
(Required.)
(Required.)
(Optional.)
(Required.)
(Required.)
Configuring applications carried by
•
(Optional.)
•
(Required.) Perform one of the following tasks:
Configuring IPoA

Configuring IPoEoA

Configuring PPPoA

Configuring PPPoEoA

(Optional.)
(Optional.)
(Optional.)

Configuring an ATM interface

Depending on the actual networking environment and system requirements, you might be required
to modify certain parameters of ATM interfaces and subinterfaces. For more information about ATM
interface configuration, see Interface Configuration Guide.

Configuring a PVC

In PVC mode, the network administrator configures the switching entries and assigns VPI/VCI
values. You can configure the PVCs by using the assigned VPI/VCI values. If the ATM interfaces of
two ATM devices are directly connected, you must configure the same VPI/VCI values for the
interfaces.
To configure a PVC:
Step
1. Enter system view.
2. Enter ATM interface view
or ATM
view.
Configuring an ATM interface
Configuring a PVC
Configuring a PVC group
Configuring the ATM AAL5 encapsulation type
Configuring the ATM service type
Configuring a VE interface
Configuring VP policing
Re-marking the CLP flag value of ATM cells
Configuring ATM OAM functions
Command
system-view
interface atm { interface-number |
subinterface
interface-number.subnumber }
ATM:
127
Remarks
N/A
N/A
N/A
N/A
N/A
When you configure IPoEoA or
PPPoEoA, you must configure VE
interfaces.
N/A
N/A
N/A
Remarks
N/A
N/A