Step
7.
Configure an IP address for the
interface.
To configure the device as the server (Method 2: Specify a DHCP address pool):
Step
1.
Enter system view.
2.
Configure DHCP.
3.
Enter interface view.
4.
Configure
the
assign an IP address from the
configured DHCP address pool
to the peer.
5.
Configure an IP address for the
interface.
To configure the device as the server (Method 3: Associate a PPP address pool with an ISP domain):
Step
1.
Enter system view.
2.
Configure a PPP address pool.
3.
(Optional.)
Configure
gateway address for the PPP
address pool.
4.
(Optional.) Configure a PPP
address pool route.
5.
Enter ISP domain view.
6.
Associate the ISP domain with
Command
ip address ip-address
Command
system-view
•
If the server acts as a DHCP
server, configure the DHCP
server and a DHCP address
pool on the server.
•
If the server acts as a DHCP
relay agent, configure the
DHCP relay agent on the
server,
DHCP address pool on the
remote DHCP server. In
addition, you must enable
the DHCP relay agent to
record relay entries, and
configure a DHCP relay
address pool.
interface
interface-number
interface
to
remote address pool pool-name
ip address ip-address
Command
system-view
ip
start-ip-address [ end-ip-address ]
[ group group-name ]
a
ip
pool
ip-address
vpn-instance-name ]
ppp ip-pool route ip-address
{
mask-length
[
vpn-instance-name ]
domain isp-name
authorization-attribute
12
and
configure
a
interface-type
pool
pool-name
gateway
pool-name
[
vpn-instance
|
mask
}
vpn-instance
ip-pool
Remarks
By default, no IP address is
configured on an interface.
This command is optional when
the PPP address pool has been
configured
with
a
gateway
address.
Remarks
N/A
For
information
configuring DHCP, see Layer 3
IP
Services
Configuration
Guide.
N/A
By default, an interface does not
assign an IP address to the
peer.
By default, no IP address is
configured on an interface.
Remarks
N/A
By default, no PPP address
pool is configured.
By default, the PPP address
pool is not configured with a
gateway address.
By default, no PPP address
pool route exists.
The destination network of the
PPP address pool route must
include the PPP address pool.
N/A
By default, no PPP address
about
Need help?
Do you have a question about the FlexNetwork MSR series and is the answer not in the manual?