Clearing Pppoe Sessions; Configuring A Pppoe Client - HPE FlexNetwork MSR series Configuration Manual

•
The regional VA pool contains VA interfaces for interfaces that do not span multiple devices,
such as Ethernet interfaces.
When you configure a VA pool, follow these guidelines:
•
To change the capacity of a VA pool, you must delete the previous configuration, and
reconfigure the VA pool.
•
Creating or removing a VA pool takes time. During the process of creating or removing a VA
pool, users can come online or go offline, but the VA pool does not take effect.
•
If the system fails to create a VA pool because of insufficient resources, you can view the
available resources by using the display pppoe-server va-pool command.
•
VA pools are memory intensive. Set their capacity depending on your network requirements.
•
Deleting a VA pool does not log off the users who are using VA interfaces in the VA pool.
To configure a VA pool:
Step
1. Enter system view.
2. Create a VA pool (centralized
devices
mode).
3. Create a VA pool (distributed
devices
mode/centralized
devices in IRF mode).
4. Create a VA pool (distributed
devices in IRF mode).

Clearing PPPoE sessions

To clear PPPoE sessions on the PPPoE server:
Step
1. Enter user view.
2. Clear PPPoE sessions.

Configuring a PPPoE client

PPPoE client configuration includes dialer interface configuration and PPPoE session configuration.
A PPPoE session can operate in one of the following modes:
•
Permanent mode—A PPPoE session is established immediately when the line is physically
up. This type of session remains until the physical link comes down or until the session is
disconnected.
•
On-demand mode—A PPPoE session is established when there is a demand for data
transmission instead of when the line is physically up. It is terminated when idled for a specific
period of time.
Command
system-view
pppoe-server
in standalone
template-number
va-volume
pppoe-server
in standalone
template-number
IRF
slot-number ] va-pool va-volume
pppoe-server
template-number
chassis-number slot slot-number ]
va-pool va-volume
Command
user-view
reset
interface
interface-number
virtual-template number }
virtual-template
va-pool
virtual-template
[ slot
virtual-template
[ chassis
pppoe-server { all
interface-type
50
Remarks
N/A
By default, no VA pool exists.
By default, no VA pool exists.
By default, no VA pool exists.
Remarks
N/A
|
N/A
|