Configuring Vp Policing - HPE FlexNetwork MSR series Configuration Manual

Step
2. Create a VT interface.
3. Configure
authentication
address.
server,
address pool to assign an
IP address to the remote
node. For the PPP client,
configure
negotiation to accept the IP
address assigned by the
server end.
4. Return to system view.
5. Create a VE interface.
6. Configure
parameters on the VE
interface. Bind the PPPoE
server to a VT interface,
and bind the PPPoE client
to a Dialer interface for
dial-in access.
7. Return to system view.
8. Enter ATM interface view
or ATM subinterface view.
9. Enter PVC view or PVC
group view.
10. Configure
mapping.

Configuring VP policing

A VP is the collection of all PVCs with the same VPI value. VP policing is used to manage the
maximum bandwidth of the VP, and monitor the traffic of the inbound and outbound directions of the
VP on a physical interface. When the maximum transmission rate of the VP exceeds the specified
value, the exceeded flows are dropped. When VP policing is applied, the parameters of PVC are still
valid. Packets can be transmitted or received only when the parameters of PVC and VP policing are
met. In calculating the traffic, the LLC/SNAP, MUX, and NLPID headers are included, but the ATM
cell header is not included.
To configure VP policing:
Command
interface virtual-template vt-number
PPP
and IP
For the PPP
configure an
For more information, see "Configuring
PPP and MP."
address
quit
interface
interface-number
PPPoE
For more information, see "Configuring
PPPoE."
quit
interface atm { interface-number |
interface-number.subnumber }
•
Enter
pvc { pvc-name [ vpi/vci ] | vpi/vci }
•
Enter
pvc-group group-number
a PPPoEoA
map
interface-number
virtual-ethernet
PVC view:
PVC group view:
bridge virtual-ethernet
135
Remarks
N/A
Configure PPP authentication
and IP address on the VT
interface instead of an ATM
interface. The IP address
configuration does not take
effect on ATM interfaces.
When you configure a static
route for the VT interface,
specify the next hop instead of
the output interface. If you
have to specify an output
interface, make sure
physical interface bound to
the VT is valid to ensure
correct packet transmission.
N/A
N/A
N/A
N/A
N/A
N/A
By default, no mappings exist.
This command references the
VE interface previously
created.
the