Configuring Bundle Ddr; Configuring A Dialer Interface To Place Calls - HPE FlexNetwork MSR series Configuration Manual

Step
3. Enable traditional DDR on
the interface.
4. (Optional.)
interface to authenticate the
caller.
Configuring an interface to receive calls through a dialer circular group
Step
1. Enter system view.
2. Create a dialer interface and
enter its view.
3. Enable traditional DDR on
the interface.
4. (Optional.)
interface to authenticate the
caller.
5. Return to system view.
6. Enter physical interface view.
7. Assign the physical interface
to a dialer circular group.

Configuring bundle DDR

Configuring a dialer interface to place calls

To configure a dialer interface to place calls, enable DDR and configure a dial string to reach the
remote site. Only one dial string can be configured for each dialer interface.
At the initiator end, the system selects a dialer interface according to the dialer-group rule
command configuration. The physical interface uses the configuration of the selected dialer interface
to place calls.
The initiator end can optionally authenticate the receiving end. To authenticate the receiving end,
configure PAP or CHAP authentication on the dialer interface.
Command
interface-number
dialer circular enable
dialer route ip next-hop-address
Configure the
[ mask network-mask-length ]
[
vpn-instance-name ] [ broadcast |
user hostname ] *
Command
system-view
interface dialer number
dialer circular enable
dialer route ip next-hop-address
Configure the
[ mask network-mask-length ]
[
vpn-instance-name ] [ broadcast |
user hostname ] *
quit
interface
interface-number
dialer circular group number
vpn-instance
vpn-instance
interface-type
173
Remarks
By default, traditional DDR is
disabled on an interface.
To receive calls from multiple
remote sites, configure
command multiple times.
You must specify the
hostname option
configuring this command.
Remarks
N/A
N/A
By default, traditional DDR is
disabled on an interface.
To receive calls from multiple
remote sites, configure
command multiple times.
You must specify the
hostname option
configuring this command.
N/A
N/A
By default, a physical interface
does not belong to a dialer circular
group.
Make sure the number arguments
in the interface dialer and dialer
circular group commands use
the same value.
this
user
when
this
user
when