Setting The Isdn Switch Type On An Isdn Interface - HPE FlexNetwork MSR series Configuration Manual

Tasks at a glance
BRI interface
(Optional.)

power
(Required.)

ISDN BRI interface
•
On
(Required.)
PRI interface

Setting the ISDN switch type on an ISDN interface

ISDN service providers in different countries implement variants of ISDN to provide varied ISDN
services. When you configure an ISDN interface, you must set the switch type on the interface to be
the same as the service provider switch type.
Table 5 shows the ISDN switch types available on an ISDN interface.
Table 5 ISDN switch type and ISDN interface compatibility matrix
Switch type
ANSI
AT&T
5ESS
DSS1
ETSI
NI
NI2
QSIG
NTT
NOTE:
The device provides full support for DSS1. For any other variants of ISDN, the device only provides
the basic call functionality.
You cannot perform this task when a call is present on the ISDN interface.
To set the service provider switch type on an ISDN interface:
Step
1. Enter system view.
2. Enter ISDN BRI or PRI
interface view.
3. Set the ISDN switch type.
Configuring a BRI interface to supply line
Configuring the sliding window size on an
a PRI
Configuring the sliding window size on an ISDN
BRI
Yes
No
No
Yes
Yes
Yes
No
No
Yes
Command
system-view
interface interface-type interface-number
isdn protocol-type protocol
Remarks
interface:
CT1/PRI
Yes
Yes
Yes
Yes
Yes
No
Yes
Yes
Yes
107
CE1/PRI
No
No
No
Yes
Yes
No
No
Yes
No
Remarks
N/A
N/A
The default is DSS1 for both
BRI and PRI.
To specify ANSI, AT&T,
ETSI, NI, or NTT, you must
make sure the interface is