Configuring Basic Dce-Side Frame Relay; Configuring Local Frame Relay Virtual Circuits - HPE FlexNetwork MSR series Configuration Manual

Step
5. (Optional.) Set the Frame
Relay interface type to DTE.
6. (Optional.)
Frame Relay LMI protocol
type.
7. (Optional.) Set the DTE-side
N391 counter.
8. (Optional.) Set the DTE-side
N392 counter.
9. (Optional.) Set the DTE-side
N393 counter.
10. (Optional.) Set the DTE-side
T391 timer.

Configuring basic DCE-side Frame Relay

Step
1. Enter system view.
2. Enter
interface connecting to the
Frame Relay network.
3. Enable
encapsulation
interface.
4. (Optional.)
encapsulation type for the
Frame Relay interface.
5. (Optional.) Set the Frame
Relay interface type to DCE.
6. (Optional.)
Frame Relay LMI protocol
type.
7. (Optional.) Set the DCE-side
N392 counter.
8. (Optional.) Set the DCE-side
N393 counter.
9. (Optional.) Set the DCE-side
T392 timer.

Configuring local Frame Relay virtual circuits

The available methods of creating virtual circuits vary by interface type.
•
On a DCE main interface or subinterface, the virtual circuit must be manually created.
•
On a DTE main interface, virtual circuits can be automatically created through negotiation with
the peer interface or manually created.
•
On a DTE subinterface, the virtual circuit must be manually created.
This section describes how to manually create virtual circuits.
Command
fr interface-type dte
Configure the
fr lmi type { ansi | nonstandard |
q933a }
fr lmi n391dte n391-value
fr lmi n392dte n392-value
fr lmi n393dte n393-value
timer-hold seconds
Command
system-view
the view of the
interface
interface-number
Frame Relay
on the
link-protocol fr
Configure the
fr
nonstandard }
fr interface-type dce
Configure the
fr lmi type { ansi | nonstandard |
q933a }
fr lmi n392dce n392-value
fr lmi n393dce n393-value
fr lmi t392dce t392-value
interface-type
encapsulation { ietf
227
Remarks
The default setting is DTE.
The default setting is q933a.
The default setting is 6.
The default setting is 3.
The default setting is 4.
The default setting is 10 seconds.
Remarks
N/A
N/A
By default, PPP encapsulation is
enabled on interfaces except
Ethernet interfaces,
interfaces, and ATM interfaces.
|
The default setting is IETF.
The default setting is DTE.
The default setting is q933a.
The default setting is 3.
The default setting is 4.
The default setting is 15 seconds.
VLAN