Managing A Modem; Feature And Hardware Compatibility; Modem Management Configuration Task List; Configuring Modem Services On A User Line - HPE FlexNetwork MSR series Configuration Manual

Managing a modem

This chapter describes how to manage and control the modems connected to the device.

Feature and hardware compatibility

This feature is available only on the following interface modules and interfaces:
•
AM interface modules.
•
ASE interface modules.
•
AUX interfaces.
•
SAE interface modules operating in asynchronous mode.

Modem management configuration task list

Tasks at a glance
(Required.)
(Required.)
(Required.)
(Optional.)
(Optional.)
(Optional.)
(Required.)

Configuring modem services on a user line

CAUTION:
This task disconnects the modem connection that has been established on the user line.
Perform this task to configure a user line for incoming modem calls, outgoing modem calls, or both.
To configure the modem access services on user lines:
Step
1. Enter
view.
Configuring modem services on a user line
Setting the answer timeout timer
Setting the modem answer mode
Enabling a modem to obtain caller numbers
Enabling modem callback
Issuing an AT command to a modem
Setting the country code of a modem
Command
system
system-view
Remarks
Configure a user line for incoming modem calls,
outgoing modem calls, or both.
Increase the answer timeout timer on a slow link
for a
establishment.
You must set the modem answer mode on a
user line to be the same as the connected
modem.
This task is for point of sale (POS) terminal
access services. Perform this task if a bank front
end processor requires the call numbers of POS
terminals for terminal identification.
Enable modem callback if the remote end
connected to the modem requires a callback.
N/A
You must set the correct country code for the
modem to operate correctly.
Remarks
N/A
147
successful modem connection