Cylinder Head Bolt; Valve Keeper; Valve Guide; Valve Seal - Ford TRADER Workshop Manual

9TGOB2·155
490107222A
9TGOB2·156
1€"1t4.I'4 .•
DISASSEMBL Y
Disassembly Note
Cylinder head bolt
B
1. Loosen the cylinder head bolts in two or three steps in the
order shown in the figure.
2. Remove the cylinder head bolts.
Valve keeper
1. Set the
SST
against the upper valve spring seat as shown
in the figure.
2. Remove the valve keepers.
Valve seal
1. Remove the valve seal with the SST.
Valve guide
Caution
• If the valve guide is removed, it must be replaced
with a new one.
1. Measure height A of each valve guide.
Height A: 15.2-15.4mm (0.598-0.606 in)
2. If height A is not wIThin specification. replace the valve guide.
3. Remove the valve guide from the side opposite the com-
bustion chamber with the SST.
6-61