Ford TRADER Workshop Manual page 630

p
PARKING BRAKE SYSTEM
Removal/Inspection I Installation
1. Release the parking brake.
2. Remove the lower panel. (Refer to Section S.)
3. Remove in the order shown in the figure.
4. Install in the reverse order of removal.
5. Inspect all parts and repair or replace as necessary.
6. After installation, inspect the stroke. (Refer to page P-37.)
0---@
~.
1. Split pin
2.
Clevis pin
3. Return spring
Inspect for deformation or weakness
4. Split pin
5.
Clevis pin
6. Parking brake rod
InspeCt for wear or damage of ratchet pawl
7. Spring
Inspect for deformation or weakness
8.
Front cable
Removal/Inspection /
r
I
i
A
10. Clevis pin
11. Nut
12. Adjusting bolt
13. Joint
14. Tension rod
Inspect for damage or deformation
15. Split pin
16. Clevis pin
17. Parking brake lever
Inspect for damage or deformation
18. Screw
19. Parking brake switch
9TFOPX-016
Installation.: ............................... page P-39
9. Split pin
Inspection ...................................... Section T
P-38