Housing Components - Ford TRADER Workshop Manual

DISASSEMBLY
Precaution
TRANSMISSION
J1
1. Clean the transmission exterior thoroughly with a steam cleaner or cleaning solvents before disassembly.
2. Clean the removed parts with cleaning solvent, and dry with compressed air.
Clean out all holes and passages with a compressed air, and check that there are no obstructions.
3. Wear eye protection when using compressed air to clean components.
Housing Components
1. Disassemble in the order shown in the figure, referring to Disassembly Note.
6
1. Center brake drum
Disassembly Note
14
..................... page
J1-18
2.
Center brake assembly
3. Transmission mount
4. Oil seal
I nspect for damage
Replace if necessary
On-vehicle replacement
..................... page J1-18
5. Top cover
Disassembly ... page J1-27
Assembly ........ page J1-33
@
6. Front cover
7.
Clutch housing
8.
Adjustment shim
9. Gasket
10. Oil
seal
Inspect for damage
Replace if necessary
11. Sub-transmission switch
12. Speedometer driven gear
13. Bolt
14. Rear housing
3
Disassembly Note
..................... page J1-18
REPLACE
15. Gasket
16. Snap ring
17. Ball bearing
Disassembly Note
9TFOJ1-(XJ9
..................... page J1-18
18. Adjustment shim
19. Shift lever
20.
Speedometer drive gear
21. Ball
22.
Spacer
J1-17