Stopper Screw - Ford TRADER Workshop Manual

p
BRAKE SYSTEM
Disassembly
I
Inspection
I Assembly
1. Remove the brake fluid from the master cylinder.
2. Disassemble in the order shown in the figure, referring to Disassembly Note.
3. Assemble in the reverse order of removal, referring to Assembly Note.
4. Inspect all parts and repair or replace as necessary.
Caution
• Do not let foreign material enter the cylinder.
• Do not scratch the inside of the cylinder or piston cups.
1. Hose connector
2. Bushing
Inspect for wear or damage
3. Stopper screw and a-ring
Disassembly note ................................ below
Assembly note ............................ page P-15
4. Snap ring
7. Joint bolt
8. O-ring
9. Oil seal
10. Spring
Inspect for wear
11 . Bleeder cap and screw
12. Cylinder body
REPLACE
5. Primary piston assembly
Inspect piston cups for damage
6. Secondary piston assembly
Inspect for crack or damage
Inspect piston cups for damage
Disassembly note ....................... page P-15
Disassembly note
Stopper screw
9TGOPX·032
1. Push the primary piston assembly in fully. then remove the
stopper screw.
9TGOPX.Q33
P-14