Clutch Hose - Ford TRADER Workshop Manual

CLUTCH MASTER CYLINDER
H
03UOHX·016
IUi·,,··iell
9TGOHX·012
9TGOHX·014
Removal Note
Clutch pipe
1. Disconnect the clutch pipe with the SST.
Clutch hose
1. Disconnect the clutch hose from the master sylinder.
2. Plug the outlet of the clutch hose.
9TGOHX.()11
Installation Note
Push rod (With vacuum power assist)
1. Set the SST on the clutch master cylinder.
2. Turn the adjusting bolt, until the end of the bolt contacts
the piston.
3. Apply a vacuum of 500 mmHg (19.7 inHg) to the vacuum
power assist using a vacuum pump.
4. Turn over the SST and set it on the vacuum power assist.
5. Verify that the clearance between the SST and the push
rod is 0.1-0.3mm (0.004-0.012 in). Adjust the push rod
if necessary.
Clutch pipe
1. Tighten the clutch pipe with the SST.
Tightening torque:
19-26 N·m (1.9-2.6 m-kg, 14-19 ft-Ib)
H-9