Oil Cooler, Oil Filter; Rear Oil Seal Cap; Water Inlet Pipe - Ford TRADER Workshop Manual

/
"
9TGOB2·312
9TGOB2·313
ASSEMBLY
B
Oil Cooler, Oil Filter
1, Install the oil cooler and a new gasket
Tightening torque:
19-25 N·m (1.9-2.6 m-kg, 14-19 ft-Ib)
2, Apply a small amount of clean engine oil to the rubber seal
of the new filter.
3. Install the oil filter and tighten it by hand until the rubber
seal contacts the base.
4. Tighten the filter 1/2-turn with a filter wrench.
Rear Oil Seal Cap
1. Install the rear oil seal cap and a new gasket
Tightening torque:
19-25
N·m
(1.9-2.6 m-kg, 14-19 ft-Ib)
2. Apply a small amount of clean engine oil to the lip of the
new oil seal.
3. Push the oil seal slightly in by hand.
Caution
• The oil seal must be
pressed in until it is flush with
,the edge of
th\·
rear oil seal cap.
4. Press the oil seal in evenly with a suitable pipe and a
hammer.···
Water Pump
1. Install the water pump and a new gasket.
Tightening torque
HA: 16-23 N·m (1.6-2.3 m-kg, 12-17 ft-Ib)
SL: 19-25 N·m (1.9-2.6
~-kg,
14-19 ft-Ib)
Water Inlet Pipe
1. Install the water inlet pipe and a new gasket.
Tightening torque:
19-25 N·m (1.9-2.6 m-kg, 14-19 ft-Ib)
8-107