Valve Housing, Worm Ball Nut Assembly - Ford TRADER Workshop Manual

ENGINE SPEED SENSING POWER STEERING
N
I€*.t#i*~,i
STGONX·074
9TGONX·075
STGONx-on
2. Remove the adjusting plug with the SST.
Valve housing, Worm ball nut assembly
Caution
• Do not damage the inside of the gear housing and
the worm ball nut assembly.
1. Remove the valve housing and the worm ball nut assem-
bly together by hitting the worm shaft end with a plastic
hammer.
2. Press the ball bearing and the oil seal out with the a socket
3. Remove the outer race with a screwdriver.
Gear housing
1. Remove the oil seal, the U-packing and the O-ring with a
screwdriver.
Caution
• Do not remove the needle bearing.
• Do
not damage the inside of the gear housing or the
needle bearing.
N-31