Front Bearing; Rear Bearing - Ford TRADER Workshop Manual

G
G-10
CHARGING SYSTEM
9TGOG1·027
REAR BEARING
BEARING PULLER
9TGOGH)28
9TGOG1·029
CRANKSHAFT PULLEY
9TGOGH)30
Front bearing
1 . Check the bearing for improper rotation and/or
abn~rmal
noise.
Replace if necessary.
Rear bearing
1 . Check the bearing for improper rotation and/or abnormal
noise.
Replace if necessary.
DRIVE BELT
Inspection
1. Visually check for wear, damage and injury on connection
between belt and pulley or damage on pulley.
Replace if necessary.
2. Check the drive belt tension with tension gauge.
Tension
(N (kg, Ib))
Engine type
HA SL SL
(4WD)
TF
Used one
245-294 343-392 373-471 383-520
(25-30, 55-66) (35-40. n-88) (38-48.83-106) (39-53, 86-117)
New one
294-392 392-491
471-569
451-520
(30-40,66-88) (40-50,88-110) (48-58,110-128) (46-53, 101-117)
3. Check the drive belt deflection by applying moderate pres-
sure (10 kg load) midway between the pulleys.
Deflection
Used one: 10-11mm (0.39-0.43 in)
14-16mm (0.55-0.63 in) (SL 4WO)
11-12mm (0.43-0.49 in) (TFengine)
New One: 9-10mm (0.35-0.39 in)
Adjustment
12-14mm (0.47-0.55 in) (SL 4WO)
10-11mm (0.39-0.43 in) (TF engine)
1. Loosen bolts A and B.
2. Move the alternator in or out to adjust the belt deflection.
(Refer to inspection part.)
3. Tighten bolts A and B to the specified torque.
Torque:
®
19-25 Nom (1.9-2.6 m-kg, 14-19 ft-Ib)
@
37-52 N·m (3_8-5_3 m-kg, 27-38 ft-Ib)