Ford TRADER Workshop Manual page 590

N
ENGINE SPEED SENSING POWER STEERING
Disassembly I Inspection I Assembly
1. The following procedures show replacement of the O-ring, bearing, Woodruff key, and oil seal. If a prob-
lem is found in other parts, replace the oil pump assembly.
2. Disassemble in the order shown in the figure, referring to Disassembly Note.
3. Inspect for all parts and replace as necessary.
4. Assemble in the reverse order of disassembly, referring to Assembly Note.
4.0 L Engine type
1. Locknut
Disassembly note ....................... page N-45
Assembly note ........................... page N-46
2. Washer
3.
Drive gear
Inspect for damage
4. a-ring
5. Suction pipe
6. a-ring
7. Connector
8. Spacer
9. a-ring
10. Control valve assembly
Inspect for damage and wear
11. Spring
Inspect for damage
12. Rear body
Inspect for damage
13. O-ring
14.
Cam ring
I nspect for damage and wear
Assembly note ........................... page N-46
15. Vane
Inspect for wear
Assembly note ........................... page N-42
16. Rotor
Inspect for damage and wear
Assembly note ........................... page N-45
N-44
N-m (60-100 cm-kg. 52-87 in-Ib)
N-m
(In-kg, ft-Ib)
9TFONX·024
17. Pressure plate
·'nspect for damage and wear
Assembly note ........................... page N-42
18. Pin
19.
Spring
Inspect for damage
20.
Snap ring
Disassembly note ....................... page N-40
21. Driveshaft
Disassembly note ....................... page N-40
Inspect for damage and wear
Assembly note ........................... page N-41
22. Spacer
23.
ail seal
Disassembly note ....................... page N-45
24. Snap ring
25. Bearing
Inspect for operation
26. Woodruff key
Disassembly note ....................... page N-40
Assembly note ........................... page N-41
27. Front body
Inspect for damage and wear
Assembly note ........................... page N-45