Ford TRADER Workshop Manual page 585

ENGINE SPEED SENSING POWER STEERING
N
Disassembly
I
Inspection
I
Assembly
1. The following procedures show replacement of the O-ring, bearing, Woodruff key, and oil seal. If a prob-
lem is found in other parts, replace the oil pump assembly.
2. Disassemble in the order shown in the figure, referring to Disassembly Note.
3. Inspect all parts and repair or replace as necessary.
4. Assemble in the reverse order of disassembly, referring to Assembly Note.
3.5
L TURBO Engine type
59-78 (6.0-8.0, 43-58)
1. Locknut
2.
Pulley
3.
Bracket
4. Connector (Return)
5. O-ring
6. Connector (Pressure)
7. O-ring
8. Plug
9. O-ring
10. Control valve assembly
Inspect for damage and wear
11. Spring
Inspect for damage
12. Rear body
Inspect for damage and wear
13. O-ring
14. Pressure plate
Inspect for damage and wear
Assembly note ........................... page N-42
15. Cam ring
Inspect for damage and wear
Assembly note ........................... page N-42
16. Vane
Inspect for wear
Assembly note ..... '" ................... page
N-42
Nom (m-kg, ft-Ib)
9TFONX·022
17. Rotor
Inspect for damage and wear
Assembly note ........................... page N-42
18.
Pin
19. Snap ring
Disassembly note ." .................... page N-40
20. Driveshaft
Disassembly note ....................... page
N-40
Inspect for damage and wear
Assembly note ........................... page N-41
21 . Retaining ring
22. Oil seal
Disassembly note ....................... page
N-41
23. Snap ring
24. Bearing
Inspect operation
25. Woodruff key
Disassembly note ....................... page
N-40
Assembly note ........................... page
N-41
26. Front body
Inspect for damage
Inspect 9peration of needle bearing
Assembly note ........................... page
N-41
N-39