Ford TRADER Workshop Manual page 334

FUEL CUT CONTROL SYSTEM
F3
9TGOF2·1S7
FUEL CUT CONTROL SYSTEM
SYSTEM OPERATION .
1. Turn the engine switch OFF and verify that the stop lever
is at the fuel stop position.
2. Turn the engine switch ON and verify that the stop lever
is at the fuel inject position.
3. Run the engine.
4. Turn the engine switch OFF and verify that the engine will
stop.
FUEL STOP CABLE
Inpection
1 . Check the cable for damage or rust
2. Turn the engine switch OFF.
3. Move the fuel stop lever to make the fuel line close.
4. Check the free play of cable in condition of tensed
®
po-
sition of the fuel stop cable.
Free play: 0-2mm (0-0.078 in)
5. Verify that the engine stops when turn the engine switch
OFF.
6. If not as specified, adjust the cable as follows.
Adjustment
1. Turn the engine switch OFF.
2. Loosen nut® and remove the fuel stop cable from the
bracket.
3. Pull the fuel stop cable and verify that the fuel stop lever
is at the fuel stop position.
4. Adjust nut
G)
so that there is no clearance between it and
the outside of the bracket.
5. Install the cable into the bracket, fitting nut
G)
into the recess.
6. Check the free play of the cable as above.
7. If not as specified perform steps 2-5 again.
8. If as specified, tighten nut ® .
9. Verify that the engine stops when turning the engine switch
OFF.
F3-29