Piston And Secondary Cup Assembly - Ford TRADER Workshop Manual

H
H-12
CLUTCH MASTER CYLINDER
Piston and secondary cup assembly·
Caution
• Hold a rag over the master cylinder to prevent the
piston and secondary cup assembly from jumping
out.
1. Remove the piston and secondary cup assembly, spacer,
and primary cup by applying compressed air through the
clutch pipe installation hole.
Assembly Note
Caution
• Before assembly, make sure all parts are completely
clean.
• Do not mix different brands of clutch fluid.
• Do not reuse the clutch fluid that was drained.
• Apply the specified clutch fluid to the piston and
secondary cup assembly, spacer, primary cup, and
cylinder bore before assembly.
• Replace parts with new ones whenever specified to
do so.
03UOHX·01g
Snap ring
Caution
• Do not damage the push rod contact surface of the
piston.
1. While pressing the piston, install the snap ring.