End Plug - Ford TRADER Workshop Manual

N
N-10
MANUAL STEERING
9TGONX·016
7
Installation note
End plug
1. Fit a grease nipple in the plug hole and apply grease (lithi-
um base NLGI No.2).
Note
• Tighten the end plug fully and then loosen it before
the adjustment.
2. Adjust the starting torque of the ball stud by turning the end
plug.
Starting torque: 5-15 kg (11-33 Ib)
Tie-rod end boot
1. Put a small amount of grease (lithium base NLGI No.2) into
the new boot and set it onto the tie-rod end. Install the boot
to the tie-rod end with the
SST
and a press.