Injection Pump - Ford TRADER Workshop Manual

F2
INJECTION PUMP
Removal
Note
FUEL SYSTEM
• The in-line type pump used on the SL and SL turbocharged engines is removed with the drive
gear. When replacing the pump be sure it is properly timed.
• Special tools and testers are required for service of the injection pump. The pump should be
serviced only by an authorized Diesel Kiki distributor.
F2-30
~.~_I-
- j
II~---
9TGOF2·071
Caution
• Before remove injection pump, perform the fol-
lowing.
1 . Remove the negative battery cable.
2. Remove the cover from the flywheel, and turn the flywheel
until No.1 cylinder is at to 30° BTDC.
3. Remove the cover from the gear case, and confirm that the
mark on the timer and the pointer are aligned.
Note
• If they are not agreed, No.4 cylinder is at 30 0 BTDC.
4. Remove in the order shown in the figure.
(Refer to page F2-31.)
Caution
• Cover the intake manifold and injection pipes after
removal. .
• After removing the pump, do not turn the engine.