Ford TRADER Workshop Manual page 33

A
A-16
SCHEDULED MAINTENANCE SERVICES
",-I~
.\.--
SL, TF Engine
Inspection
Note
• Usually it is enough to confirm that the external
- marks are
~ligned.
9TGOAX·031
Caution
• Direct injection engines are sensitive to injection
timing. Incorrect timing will cause engine knocking
or low power output.
Set the injection timing after installing the injection
pump.
1. Remove the service hole covers from the clutch housing
and the timing gear case.
2. Turn the flywheel in the direction of rotation until the indica-
tor pin is at 30° BTDC.
3. Verify that the pointer of the timing gear case and the mark
on the timer are aligned.
4. If not as specified, adjust the injection timing.
Adjustment
1. Remove the fuel stop cable from the cut lever.
2. Remove the accelerator cable from the control lever.
3. Remove the bracket.
4. Loosen injection pipes No.2-4 at the pump.
5. Remove No.1 injection pipe and the delivery valve holder.