Selection Arm And Change Lever - Ford TRADER Workshop Manual

9TGOJ2'()60
9TGOJ2·061
TRANSMISSION
J2
Selection arm and change lever
1. Measure the clearance between the selection arm and the
change lever.
Clearance: 0.8mm (0.032 in) max.
Clutch hub assembly
1. Inspect the clutch hub sleeve and hub operation.
2. Inspect the gear teeth for damage, wear and cracks.
3. Inspect the synchronizer keys for damage, wear and cracks.
·4. Measure the clearance between the hub sleeve and the re-
lease fork.
Clearance: 0.8mm (0.031) max.
Synchronizer ring
1. Inspect individual synchronizer ring teeth for damage, wear
and cracks.
2. Inspect the taper surface for wear and cracks.
Note
• Set the synchronizer ring squarely in the gear; then
measure around the circumference.
3. Measure the clearance betWeen the synchronizer ring and
the flank surface of the gear.
Clearance: 1.0mm (0.039 in) min.