Oil Strainer And Oil Pipe - Ford TRADER Workshop Manual

9TGOB2·277
9TG0B2·281
ASSEMBLY
B
2. HA Engine
(1) Align the marks, and install the injection pump gear.
(2) Install the friction gear and lock plate.
Tightening torque:
39-69 N·m (4.0-7.0 m-kg, 29-51 ft-Ib)
Timing Gear Cover
1. Install the timing gear cover and a new gasket.
Tightening torque:
19-25 N·m (1.9-2.6 m-kg, 14-19 ft-Ib)
2. Apply a small amount of clean engine oil to the lip of the
new oil seal. .
3. Push the oil seal slightly in by hand.
Caution
• The oil seal must be pressed in until it is 6.5mm
(0.26 in) inside the edge of the timing gear cover.
4. Press the oil seal in evenly with the SST (HA) or a suitable
pipe (SL) and a hammer.
Oil Pump
1 . Apply clean engine oil to the oil pump driven gear.
2. Install the oil pump.
Tightening torque:
37-53 N·m (3.8-5.4 m-kg, 27-39 ft-IP)
Oil Strainer and Oil Pipe
1. Install the oil strainer and a new gasket.
Tightening torque:
7.8-11 N-rn (80-110 em-kg, 69-95 in-Ib)
2. Install the oil pipe and a new gasket (oil pump side) and
a new O-ring (cylinder block side).
Tightening torque
@: 7.8-11 N-m (80-110 em-kg, 69-95 in-Ib)
@:
19-25 N·m (1.9-2.6 m-kg, 14-19 ft-Ib)
8-99