Ford TRADER Workshop Manual page 438

J1
B
A
CASE ADAPTER
9TGOJ1-102
9TGOJ1·l03
9TGOJ1·l04
..
.
"
9TGOJ1·1OS
•• ·1
9TGOJ1·l06
J1-42
TRANSMISSION
Assembly Note
Adjustment shim
1 . After measuring dimensions A and B shown in the figure,
use an adjustment shim(s) with the thickness correspond-
ing to the value of A plus gasket thickness 0.3mm (0.012
in) minus B, so that bearing end play will be within specifi-
cation.
Bearing end play:
0-0.1
mm
(0-0.004
in)
Adjustment shim thickness:
0.8 (0.031) 0.9 (0.035) 1.0 (0.039)
1.1 (0.043) 1.2 (0.047)
Locknut
1. Slide the clutch hub sleeves onto 1 st and reverse gears to
lock the mainshaft.
2. Tighten the new locknut.
Tightening torque:
157-235 N-m (16--24
m-kg,
116-174
ft-Ib)
3. Use a chisel to stake the locknut.
Shift fork and shift rod
1. Install the shift fork and shift rod into the case adapter.
Bearing
1. Install the bearing with the SST.
Output shaft bearing
1. Install the bearing with the SST .