Sony MVS-8000X User Manual page 41

2
Using any of the following methods, select the bank to
be recalled.
To select bank 0: press the [BANK0] button.
To select bank 1: press the [BANK1] button.
To select any of banks 0 to 9: press the [BANK SEL]
button; the memory recall section display changes
as shown in the following figure; press one of 0 to
9.
The selected bank number appears in the numeric
display.
The memory recall section buttons show the register
names corresponding to the selected bank, and the
register status.
Note that by a setting in the Setup menu, you can select
either register names or register numbers to be
displayed.
Lit orange: register holding the master timeline
Lit yellow: last recalled register
Off: empty register
3
Press the button in the memory recall section which
shows the desired register name.
The button you pressed lights yellow, and the master
timeline is recalled. The numeric display shows the
bank number, followed by the selected register
number.
Recalling a register from the Multifunction
Flexi Pad control block
EFF button Alphanumeric display
Memory recall section
Region selection buttons
1
Press the [EFF] button, turning it on.
2
Press the button corresponding to the region you want
to select, turning it on.
You can also press more than one button.
[M/E 1], [M/E 2], [M/E 3], [M/E 4], [M/E 5], [P/P]:
These select the corresponding M/E-1, M/E-2, M/
E-3, M/E-4, M/E-5, and PGM/PST regions.
Notes
To select [M/E 4] or [M/E 5], a previous button
assignment in the Setup menu is required (see page
165).
[USER 1] to [USER 8]: These select the User regions.
[DME 1] to [DME 8]: These select the DME
channels.
[PBUS]: This selects P-Bus.
[GPI]: This selects GPI.
[MCRO]: This selects Macro.
[DEV 1] to [DEV 12]: This selects device.
[ALL]: This selects all valid regions.
[MSTR]: This selects the master timeline.
For details, see "Creating and Saving a Master
Timeline Using the Buttons in the Multifunction Flexi
Pad Control Block" (page 60).
Notes
The regions that can be selected simultaneously are
those assigned to the region selection buttons in the
Multifunction Flexi Pad control block, and those
displayed on the memory recall section buttons when
the [MORE] button is pressed (see page 165).
When [MSTR] and other regions are selected
simultaneously, the master timeline takes precedence.
The first button pressed lights green as the reference
region. Subsequently pressed buttons turn amber for
the region select buttons and yellow for the memory
recall section buttons.
Pressing one of the amber or yellow buttons, while
holding down [EFF], turns the button green to indicate
its corresponding region as the new reference region.
For details of the precedence order for becoming the
reference region, see "Reference region" (page 29).
The display shows the name of the reference region,
and the number of the last register recalled for this
region.
3
Enter the number of the register you want to recall,
using the numeric keypad.
To find an empty register, instead of entering a
number, press the [.] (period) button. To search for an
41
Recalling a Register