Copying Files - Sony MVS-8000X User Manual

• To select a single file, press the arrow keys to scroll
the reverse video cursor, or press directly on the list
in the status area.
5
Press [T Load].
This loads the contents of the selected file from the
specified location (setup data is loaded first).
Loading frame memory files
Between steps 3 and 4 of the procedure above, "Loading
Files," do as follows.
Notes
• When the signal format is 1080P, extended clip files
cannot be recalled.
• In a still image file saved in 1080P signal format, there
are two still image files for each frame. If either of these
two files is missing, it is not possible to recreate the
image, and therefore for correct operation the two files
must always be recalled together.
1
To select the frame memory folder, press [Default] in
the device selection in the list on the left.
A pull-down menu appears.
2
Press the required folder name.
3
Carry out the same operations as in steps 1 and 2 on
the list on the right.
4
Select the type of data to be displayed.
• To display still image files, press [Still].
• To display clip files, press [Clip].
• To display extended clip files, press [Ext Clip].
• To display all types of file, press [All].

Copying Files

You can copy files either within a directory or between
directories, on the hard disk, or memory card.
As an example, to copy a snapshot file from memory card
to hard disk, use the following procedure.
1
In the File menu, select VF3 'Snapshot' and HF1
'Snapshot.'
2
In the device selection area on the left, specify the
location of the file to be copied (in this case [Memory
Card] and a directory) (see page 128).
3
In the device selection area on the right, select the
destination of the copied file (in this case [HDD] and a
directory).
130
Operations on Individual Files
4
Using any of the following methods, select the source
and destination files.
• To select all files within the list, press [ALL] below
the list.
• To select multiple files, turn the knobs to select in
the following ranges.
Knob Parameter Adjustment
1 List L Select the first
copy source file
2 List R Select the first
destination file
3 Num Number to be
selected
• To select a single file, press the arrow keys to scroll
the reverse video cursor, or press directly on the list
in the status area.
5
Press [t Copy].
This copies the selected file or files to the specified
destination.
If there is already data in the specified location, a
confirmation message appears.
• Select "Yes" to overwrite the data.
• Select "No" to cancel copying all of the files.
Copying frame memory files
Between steps 3 and 4 of the procedure above, "Copying
Files," do as follows.
Notes
In a still image file saved in 1080P signal format, there are
two still image files for each frame. If either of these two
files is missing, it is not possible to recreate the image, and
therefore for correct operation the two files must always be
copied together.
1
To select the frame memory folder, press [Default] in
the device selection in the list on the left.
A pull-down menu appears.
2
Press the required folder name.
3
Carry out the same operations as in steps 1 and 2 on
the list on the right.
4
Select the type of data to be displayed.
• To display still image files, press [Still].
• To display clip files, press [Clip].
• To display extended clip files, press [Ext Clip].
• To display all types of file, press [All].
Setting values
1 to 99
1 to 99
1 to 99