Sony MVS-8000X User Manual page 290

Icon Message
Restore Data
Restoring...
Success!!
Recovery binary on the USB storage
device is not found.
Failure.
Copying recovery data hasn't finished.
Set Time/Date
Error: Wrong Format.
Trim
The Start TC or Stop TC is not
properly set.
This file is locked.
This file is using for playback.
Warning
This operation will be cancelled,
because the register is locked.
Please change the register status to
be unlocked first.
No Switcher information available.
Please confirm "Network
Configuration" on Page 7311.
Warning (System Config)
Illegal Network Config Information
(Page 7311)
Illegal Panel Assign Information for
Dual Simul Operation (Page 7312)
No Panel Assign Information (Page
7312)
No Switcher Assign Information (Page
7312)
No System Operation Mode
Information (Page 7312)
No DME Channel Information
a) MKS-8010A only
290
Error Messages
Description
Recovery data is being restored using menu 9999.
Restoring recovery data using menu 9999 was completed successfully.
When restoring recovery data using menu 9999, recovery data could not be
found on the memory card. Check that the recovery data has been correctly
copied to the memory card, restart the system, and try again.
Restoring recovery data using menu 9999 failed. Check that the recovery
data has been correctly copied to the memory card, restart the system, and
a)
try again.
7317: Engineering Setup >System >Maintenance
A correct date and time was not specified. Specify the correct date and time.
2522: Frame Memory >Clip >Play
When [Trim] was pressed, neither the Start TC nor the Stop TC was set.
2522: Frame Memory >Clip >Play
When [Trim] was pressed, the interval between Start TC (or Clip Begin) and
Stop TC (or Clip End) was the entire clip.
2522: Frame Memory >Clip >Play
When [Trim] was pressed, the Start TC (or Clip Begin) value was greater
than the Stop TC (or Clip End) value.
2522: Frame Memory >Clip >Play
When [Trim] was pressed, the file was locked.
2522: Frame Memory >Clip >Play
When [Trim] was pressed, the target file was being played back.
6211.1: Effect >Master Timeline >Store >Edit
6311.1: Snapshot >Master Snapshot >Store >Edit
6411.1: Shotbox >Register >Store >Edit
When [Store] was pressed, the target register was locked. Unlock the
register before executing [Store].
When starting up the menu system, the switcher was not present in the
system information. Check the Data LAN connections, and retry [Auto
Config] in menu 7311 (Engineering Setup >System >Network Config).
When starting up the menu system, one of the messages on the left
appears, depending on the status, if the system information read from the
control panel is not correct.
According to the message, execute menu 7311 (Engineering Setup
>System >Network Config) or 7312 (Engineering Setup >System >System
Config) again.
a)
a)
a)