Setting The Tbc Window Center Position; Settings Relating To Signal Outputs (Output Menu); Adjusting The Dme1 And Dme2 Output Video; Clip Levels - Sony MVS-8000X User Manual

1
In the DME >Input menu, press [System Phase].
2
Set the following parameters.
Knob Parameter Adjustment
1 DME1 DME1 system
Phase phase
adjustment
2 DME2 DME2 system
Phase phase
adjustment
Setting the TBC Window Center
Position
1
In the DME >Input menu, press [TBC Center].
The TBC Center menu appears.
The status area shows the TBC center position values
for DME1, DME2, and external input signals.
Notes
The TBC center position values for external input
signals are shown only when an MVE-9000 or MKS-
7470X/7471X is used.
2
Using any of the following methods, select the input
number for which you want to set the TBC center
position.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knob.
Knob Parameter Adjustment
1 No Input number
selection
3
In the <Video/Key> group (when SDI-interfaced
MVE-8000A/9000 is used) or <External Video>
group (when MVE-9000 or MKS-7470X/7471X is
used), press the desired button, and set the TBC center
position to 0H, 0.5H, or 1H.
Settings Relating to
Signal Outputs (Output
Setting values
Menu)
–32.00 to
+96.00
To make settings relating to DME output signals, display
–32.00 to
the DME >Output menu.
+96.00
You can select the signals output from the four monitor
output connectors.
To display the Output menu
In the Engineering Setup menu, select VF4 'DME' and
HF3 'Output.'
The following functions are available here.
• Clip Adjust: Adjust the video clip levels of DME1 and
DME2 outputs. These settings are possible only when
the DME is an MVE-9000 or SDI-interfaced MVE-
8000A.
• Monitor Output: Set the signals output from the four
monitor output connectors.
Adjusting the DME1 and DME2
Output Video Clip Levels
When the MVE-8000A/MVE-9000 is connected through
SDI interface, you can adjust both DME1 and DME2
output video clip levels.
Use the following procedure (DME 1 is taken by way of
example).
1
In the <DME1 (Ch1-Ch4)> group of the DME
>Output menu, press [Clip Adjust], turning it on.
Setting values
2
Set the following parameters.
1 to 8
Knob Parameter Adjustment
1
2
3
To return the setting to the default value
In the DME >Output menu, press [Default].

Setting the Monitor Output

To set the signals output from the four monitor output
connectors, use the following procedure.
1
In the DME >Output menu, press [Monitor Output].
White Clip White clip
adjustment
Dark Clip Dark clip
adjustment
Chroma Chroma clip
Clip adjustment

Settings Relating to Signal Outputs (Output Menu)

Setting values
90.00 to 109.02
−6.85 to +10.00
90.00 to 113.17
231