Changing The Wiring Settings; Deleting Wiring Settings; Sorting Wiring Settings; Tally Generation Settings (Tally Enable Menu) - Sony MVS-8000X User Manual

Knob Parameter Adjustment
4 Source
(From)
5 Source
(Level)
4
Press [Execute].
This makes the wiring setting according to the
specifications in steps 2 and 3.

Changing the Wiring Settings

1
In the Router/Tally >Wiring menu, press [Modify].
The Modify menu appears.
2
Referring to steps 2 and 3 in the preceding section
"Making New Wiring Settings," change the
parameters as required. In this case, however, it is not
possible to specify multiple destinations in a single
operation, and a single "Destination Address" must be
specified.
3
Press [Execute].

Deleting Wiring Settings

1
In the Router/Tally >Wiring menu, using either of the
following methods, select the wiring whose settings
you want to delete.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video
cursor.
2
Press [Delete].

Sorting Wiring Settings

In the Router/Tally >Wiring menu, press [Sort].
The sorting of wiring settings is executed in the following
order.
Destination level order (ascending)tDestination address
order (ascending)tSource level order (ascending)
250

Tally Generation Settings (Tally Enable Menu)

Setting values
Source start 1 to 1024
address
Source level 1 to 8
Tally Generation Settings
(Tally Enable Menu)
For settings relating to tally generation, use the Router/
Tally >Tally Enable menu.
Specify the destination to be the reference for tally
generation, and make various settings.
The settings are common to the parallel and serial tallies.
To display the Tally Enable menu
In the Engineering Setup menu, select VF6 'Router/Tally'
and HF4 'Tally Enable.'
The status area shows the tally generation settings.
The following functions are available here.
• Tally Type: Specify the tally type.
• Destination: Specify the address and level.
• Tally Enable: Specify the timing at which a tally is
enabled.
- Enable: Always enabled.
- Disable: Always disabled.
- Tally Input: Follow the tally input status.
Making New Tally Generation
Settings
1
In the Router/Tally >Tally Enable menu, press [New].
The New menu appears.
2
Turn the knobs to set the following parameters.
Knob Parameter Adjustment
1 Destination Destination
Address address
2 Destination Destination level
Level
3 Tally Type Tally type
a) 1:R1, 2:G1, 3:R2, 4:G2, 5:R3, 6:G3, 7:R4, 8:G4, 9:R5, 10:G5, 11:R6,
12:G6, 13:R7, 14:G7, 15:R8, and 16:G8 (R is an abbreviation of
"Red Tally," and G of "Green Tally").
3
In the <Tally Enable> group, specify the tally
generation mode.
Enable: Always generate a tally.
Disable: Never generate a tally.
Tally Input: Generate a tally from the tally input state.
4
When you selected Tally Input as the tally generation
mode in step 3, select either of the following in the
<Tally Input> group.
Setting values
1 to 1024
1 to 8
a)
1 to 16