Sony MVS-8000X User Manual page 75

enter the desired register number from the numeric
keypad. The number you entered appears in the
alphanumeric display.
To find an empty register, press the [.] (period) button
without entering a number, and the number of an empty
register appears in the alphanumeric display.
Confirm the displayed number by pressing the [ENTR]
button. This saves the data in the specified register.
To cancel a snapshot save operation
Hold down the [STOR STAT] button and press the
[UNDO] button.
The light of [STOR STAT] button changes from yellow to
green.
Adding attributes in the Multifunction Flexi
Pad control block
1
Press the [EDIT ENBL] button.
The button indications in the memory recall section
change as shown in the following illustration.
To cancel adding attributes, press the [EDIT ENBL]
button once more, or press the [EXIT] button.
• When the reference region is M/E-x (x is a number)
or P/P
• When the [PAGE 1/2] button is pressed to display
the second page
• When the reference region is other than M/E-x or P/
P, and effect dissolve settings are possible
2
Add attributes (see page 67) with the following
buttons.
[TEMP ATTR] button: Set a temporary attribute. Set
this to Off to add an attribute.
[EFF DISS] button: Add the effect dissolve attribute.
[DUR xxx] button: Set the effect dissolve duration.
The current setting is shown by "xxx." When you
press this button, the memory recall section
switches to numeric keypad input mode, and you
can enter the setting value.
[AUTO TRNS] button: Add the auto transition
attribute.
[XHLD xxx] button: Add the bus cross-point hold
attribute.
The affected bus is shown by "xxx."
Recalling a snapshot in the Multifunction
Flexi Pad control block
As an example, to recall a snapshot on the M/E-1 bank, use
the following procedure.
1
In the Multifunction bank Flexi Pad control block,
press the [SNAPSHOT] button.
This assigns the Multifunction Flexi Pad control block
to snapshot operations.
The alphanumeric display shows the register number
last recalled on the bank.
2
Press the region selection button corresponding to the
region you want to recall, turning it on. Multiple
selections are also possible.
[M/E 1], [M/E 2], [M/E 3], [M/E 4], [M/E 5], [P/P]:
These select the corresponding M/E-1, M/E-2, M/
E-3, M/E-4, M/E-5, and PGM/PST regions.
Notes
To select [M/E 4] or [M/E 5], a previous button
assignment in the Setup menu is required (See
page 165).
Snapshot Operations in the Multifunction Flexi Pad Control Block
75