Loading Files - Sony MVS-8000X User Manual

Notes
For key snapshots, snapshots, and effects, you cannot
perform the following operation when [Src Patch Link] is
lit on the menu screen (see page 257).
1
In the File menu, select VF3 'Snapshot' and HF1
'Snapshot.'
2
In the device selection area on the left, select
[Register].
3
In the device selection area on the right, select [HDD]
or [Memory Card], then select a directory.
See "Selecting a Device for Operations" (page 128).
4
Using either of the following methods, select the data
to be saved, and the file in which to save it.
• To select all files within the list, press [ALL] below
the list.
• To select multiple files, turn the knobs to select in
the following ranges.
Knob Parameter Adjustment
1 List L Select the first
register whose
data is to be
saved
2 List R Select the first file
to which data is to
be saved
3 Num Number of
registers to be
selected
• To select a single file, press the arrow keys to scroll
the reverse video cursor, or press directly on the list
in the status area.
5
Press [t Save].
This saves the selected register data in the specified
location.
If there is already data in the specified location, a
confirmation message appears.
• Select "Yes" to overwrite the data.
• Select "No" to cancel saving all of the data.
Saving frame memory files
Notes
When the signal format is 1080P, saving a still image file
creates two still image files for each frame. An 'A' is
automatically appended to the first file name, and a 'B' is
appended to the second file name. If either of these files is
missing, it is not possible to recreate the image, and
therefore for correct operation the two files must always be
handled together.
Between steps 3 and 4 of the procedure above, "Saving
Files," do as follows.
1
To select the frame memory folder, press [Default] in
the device selection in the list on the left.
A pull-down menu appears.
2
Press the required folder name.
3
Carry out the same operations as in steps 1 and 2 on
the list on the right.
4
Select the type of data to be displayed.
• To display still image files, press [Still].
• To display clip files, press [Clip].
• To display extended clip files, press [Ext Clip].
• To display all types of file, press [All].

Loading Files

Setting values
1 to 99
As an example, to load a snapshot file from hard disk or
memory card to a register, use the following procedure.
1
In the File menu, select VF3 'Snapshot' and HF1
1 to 99
'Snapshot.'
2
In the device selection area on the left, select
1 to 99
[Register].
3
In the device selection area on the right, select where
the file is held ([HDD] or [Memory Card]), and then
specify a directory.
See "Selecting a Device for Operations" (page 128).
4
Using any of the following methods, select the register
to which you want to load, and the file to be loaded.
• To select all files within the list, press [ALL] below
the list.
• To select multiple files, turn the knobs to select in
the following ranges.
Knob Parameter Adjustment
1
2
3
List L Select the first
register into
which the data is
to be loaded
List R Select the first file
in which data is
held
Num Number to be
selected
Operations on Individual Files
Setting values
1 to 99
1 to 99
1 to 99
129