Making Link Table Settings; Linking Cross-Point Buttons And Gpi Output Ports - Sony MVS-8000X User Manual

5
Using any of the following methods, select the bus to
be the link source, and press [Bus Set].
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knob.
Knob Parameter Adjustment
2 No
a) Only when [Master Bus] is selected, M/E-1 to M/E-5 Trans PGM,
and P/P Trans PGM are available.
Only when [Linked Bus] is selected, AUX 1 to AUX 48 as Key are
available.
Notes
With one of M/E-1 to M/E-5 Trans PGM and P/P
Trans PGM selected for [Master Bus], the link setting
become effective as soon as you start moving the fader
lever.
6
In the <Bus Select> group, select [Linked Bus] (link
destination bus).
7
Referring to step 5, select the bus to be the link
destination, and press [Bus Set].
8
Turn the knob to select the link table, and press [Link
Table Set].
Knob Parameter Adjustment
3 Link Table
No
For more information about link tables, see the
following item.
The selected link table number is confirmed, and this
is reflected in the status area.
To delete a link
Select the link you want to delete, then press [Clear] in the
Switcher >Link >Internal Bus Link menu.

Making Link Table Settings

1
In the Switcher >Link >Internal Bus Link menu, press
[Link Table Select].
The Link Table Select menu appears.
2
Using any of the following methods, select the link
source and link destination signals.
• Press directly on the list in the status area.
222
Settings Relating to Function Links (Link Menu)
Setting values
Bus selection 1 to maximum
a)
value
Setting values
Link table 1 to 8
selection
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knobs.
Knob Parameter Adjustment
4 Main No Video/key signal
for link source
5 No Video/key signal
for link
destination
3
To confirm the selection, press [Link Src Set].
This links the link destination signal to the signal
selected as Main No.
To initialize the set source address
In the Switcher >Link >Internal Bus Link >Link Table
Select menu, press [Init Link Table].
A confirmation message appears; press [Yes].
The source addresses are reassigned, and this is reflected
in the status area.
To change the link number and link table number
In the Switcher >Link >Internal Bus Link >Link Table
Select menu, you can also change the link number and link
table number. To do this, turn the knobs as follows to make
the setting, then press [Link Table Set].
Knob Parameter Adjustment
1 Link No Link to which setting
applies
3 Link Table Link table selection
No
Linking Cross-Point Buttons and
GPI Output Ports
To link cross-point buttons or the [CUT] and [AUTO
TRANS] buttons in the cross-point control block, and GPI
output ports, use the following procedure.
1
In the Switcher >Link menu, press [GPI Link], to
display the Switcher >Link >GPI Link menu.
The status area shows the output ports and the link
status, and delay value information.
2
Using any of the following methods, select the GPI
output port.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knob.
Setting values
1 to 300
1 to 300
Setting values
1 to 64
1 to 8