Sony MVS-8000X User Manual page 40

Notes
To select [M/E 4] or [M/E 5], a previous button
assignment in the Setup menu is required (see page
165).
[USER 1] to [USER 8]: These select the User regions.
[DME 1] to [DME 8]: These select the DME
channels.
[DEV 1] to [DEV 12]: These select the regions Device
1 to Device 12, respectively.
[P-BUS]: This selects P-Bus.
[GPI]: This selects GPI.
[MCRO]: This selects Macro.
[ALL]: This selects all valid regions.
[MASTR]: This selects the master timeline (see page
59)
Notes
The regions that can be selected simultaneously are
those assigned to the region selection buttons in the
numeric keypad control block (see page 165).
It is not possible to select [MASTR] and other regions
simultaneously. If selected simultaneously, the master
timeline takes precedence.
The first button pressed lights green as the reference
region, and any subsequently pressed buttons light
amber.
Pressing one of the amber-lit buttons, while holding
down [EFF], turns the button green to indicate its
corresponding region as the new reference region.
For details of the precedence order for becoming the
reference region, see "Reference region" (page 29).
The display shows the name of the reference region,
and the number of the last register recalled for this
region.
3
Enter the number of the register you want to recall,
using the numeric keypad.
To find an empty register, instead of entering a
number, press the [.] (period) button. To search for an
empty register common to all currently selectable
regions, press the [.] button again.
To search for an empty register in the 100 range, press
[1], [0], [0], [.] (period) in that order. Similarly, to
search for an empty register in the 200 range, press [2],
[0], [0], [.] (period), and to search for an empty register
in the 300 range, press [3], [0], [0], [.] (period).
The register number appears in the display. If the
number is followed by a letter "e" or "E," this indicates
the following.
e: The selected register is empty for the regions
selected in step 2.
40
Recalling a Register
E: The selected register is empty for all currently
selectable regions.
4
To apply a temporary attribute (effect dissolve), press
the [+/–/EFF DISS] button.
Notes
It is not possible to apply temporary attributes to the
master timeline.
5
Press the [ENTER] button.
This recalls the specified register.
When the master timeline is recalled, the region
selection buttons light according to the saved region
information.
To undo the recall of a register
Immediately after recalling the register, press the [UNDO]
button to undo the operation.
Notes
After recalling the master timeline, you cannot undo the
recall.
Recalling the master timeline in the Flexi
Pad control block
Whichever block you recall the master timeline from, the
region set when it was saved is recalled.
EFF button
Memory recall section
Flexi Pad control block (standard type)
1
In the Flexi Pad control block, press the [EFF] button.
This assigns the Flexi Pad control block to master
timeline operation.
The previously selected bank number and last recalled
register number appear in the numeric display.
Numeric display
Bank selection buttons