Vtr/Disk Recorder/Extended Vtr Timeline - Sony MVS-8000X User Manual

The Device >DDR/VTR >Cueup & Play menu
appears.
The status area shows the device number, register
number, status information, current time, start point,
stop point, and start delay time.
2
Using any of the following methods, select the device.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knob.
Knob Parameter Adjustment
1 Dev Device number 1 to 12
3
Carry out any of the following operations as required.
• To set the start point, press [Set] in the <Start TC>
group.
• To set the stop point, press [Set] in the <Stop TC>
group.
• To set the start delay time, press [Set] in the <Delay>
group.
A timecode window appears.
4
Set the timecode value for the start point, stop point, or
start delay time.
Notes
You can enter a start delay time in the range that
depends on the signal format as follows:
00:00 to 59:nn,
where nn = (number of frames per second) – 1
frame.
5
Press [Enter].
Clearing the start point, stop point, and
start delay time settings in a menu
In the Device menu, use the following procedure.
1
Press VF3 'DDR/VTR' and HF1 'Cueup & Play.'
2
Using any of the following methods, select the device
for which you want to clear the settings.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knob.
Knob Parameter Setting
1 Dev Device number
3
Carry out any of the following operations as required.
• To clear the start point, press [Clear] in the <Start
• To clear the stop point, press [Clear] in the <Stop
• To clear the start delay time, press [Clear] in the
This clears the setting of the start point, stop point, or
start delay time.
Selecting Loop or Recue as the playback
mode
Setting values
You can set the device operation mode to loop or recue.
Loop: Carry out playback from the start point of a file to
the stop point, then indefinitely repeat playback from
the start point.
Recue: Carry out playback from the start point of a file to
the stop point, then return to the start point and stop.
Notes
Loop and recue functions are only available when using
the video disk communications protocol. Note that these
functions may not operate, depending on the connected
device.
In the Device menu, use the following procedure.
1
Press VF3 'DDR/VTR' and HF1 'Cueup & Play.'
The Device >DDR/VTR >Cueup & Play menu
appears.
The status area shows the device number, register
number, status information, current time, start point,
stop point, start delay time, and playback mode.
2
Using any of the following methods, select the device.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video
• Turn the knob.
3
In the <Mode> group, press [Loop] or [Recue], turning
it on.
VTR/Disk Recorder/Extended VTR
Timeline
Setting values
For a keyframe effect controlled from the center control
panel, the timeline allows you to set a VTR, disk recorder
1 to 12
or Extended VTR action at a keyframe point on the
timeline.
TC> group.
TC> group.
<Delay> group.
cursor.
Knob Parameter Adjustment
1 Dev Device number 1 to 12
Control of VTRs, Extended VTRs, and Disk Recorders
Setting values
23