Sony MVS-8000X User Manual page 218

Setting the transition preview mode
To select the transition preview mode, in the <Transition
Preview> group of the Transition menu, select either of the
following.
One Time: The transition preview ends after a single
transition.
Normal: Switching the [TRANS PVW] button on or off
switches between the transition preview mode and the
normal mode.
Selecting the transition mode of the
independent key transition control block
To select the key transition mode, select either of the
following in the <Key Transition> group of the Transition
menu.
Same: The transition settings for the On and Off directions
are the same.
Independ: The transition settings for the On and Off
directions can be set separately.
Selecting the background transition flip-
flop mode
In the Transition menu, press [Bus Toggle], to switch
between on and off.
On: Flip-flop mode
Off: Bus fixed mode
For details, see "Fader Lever Operation in Bus Fixed
Mode" in Chapter 3 (Volume 1).
Setting the split fader to be enabled or
disabled
In the Transition menu, press [Split Fader] to switch
between Enable and Disable. This setting is only valid
when using a simple transition module with Bus Toggle set
to Off.
Enable: When the fader lever is split, the split fader effect
is enabled.
Disable: Even when the fader lever is split, the normal
fader lever effect is obtained.
Enabling/disabling the fade-to-black
function
In the <FTB> group of the Transition menu, press the
program output name to toggle between On and Off.
On: Enables fade to black.
Off: Disables fade to black.
Notes
The PGM2 to PGM4 settings are only valid in Multi
Program mode or DSK mode.
218
Settings Relating to Video Switching (Transition Menu)
Setting a preset color mix
1
In the Switcher >Transition menu, press [Preset Color
Mix].
The Preset Color Mix menu appears.
The status area shows the stroke mode setting for each
M/E bank, the setting for whether or not the key status
is maintained, and the one-time mode setting.
2
In the <Stroke Mode> group, select whether to carry
out a transition in one stroke or two strokes.
Normal: Carry out a preset color mix with two
transition operations.
Single: Carry out a preset color mix with a single
transition operation.
Notes
In bus fixed mode (see page 218), the setting is fixed
to "Single."
3
In the <Non Drop Key> group, select the key setting
for a transition including a key.
To carry out the transition with the key state
maintained, press [Key1] to [Key8], turning them on.
4
If each time a transition ends the transition type is to
return to the previous setting, press [One Time
Enable].
Settings relating to fader lever operations
To select the way in which the fader lever position and the
transition progress are related, use the following
procedure.
1
In the Switcher >Transition menu, press [Transition
Curve].
The Transition Curve menu appears.
2
In the <Fader Curve> group, select the fader lever
operation mode.
Normal: The transition progress is linear, according to
the fader lever position (factory default setting).
Adv Tally Mode: When the fader lever is moved from
the end of its travel, the tally is output slightly
before the transition starts.