Undoing An Edit Operation; Duration Mode Setting; Transition Mode Settings For User Programmable Dme - Sony MVS-8000X User Manual

FM TO
3
Enter the keyframe number for the new start point, and
press the [ENTER] button.
4
Enter the keyframe number for the new end point, and
press the [ENTER] button.
The display shows the currently set loop count.
5
To change the setting, press the [CLEAR] button.
This clears the set loop count.
COUNT
6
Enter the new loop count, and press the [ENTER]
button.
Executing a keyframe loop
In the keyframe control block, press the [RUN] button.
The set loop range is executed repeatedly for the set loop
count number of times.
The Timeline menu shows the total loop count and the
number of loops remaining. If the loop count is infinite
(inf), the remaining number is not shown.
If the [REV] button is lit, the loop is played in the reverse
order.
Canceling keyframe loop execution
Press the [REWIND] button in the keyframe control block.
Changes to the loop range caused by
keyframe insertion/deletion
When a keyframe is inserted or deleted within the loop
range, the loop range also changes. The following are
examples.
Example 1: If keyframe 3 is deleted, the loop end point
moves forward as follows.
Before deletion
Deletion
After deletion
Example 2: If keyframe 3 is added, the end point keyframe
number moves back.
Before addition
After addition
Example 3: If the keyframe at the end of the loop range
(the end point) is deleted, the keyframe loop settings
are all cleared, as follows, and the [KF LOOP] button
goes off. The same occurs if the first keyframe in the
loop range (the start point) is deleted.
Before deletion
After deletion

Undoing an Edit Operation

To undo a keyframe insert, modify, delete, or paste
operation immediately after execution, press the [UNDO]
button.

Duration Mode Setting

There are two keyframe duration modes: variable duration
mode, and constant duration mode in which the effect
duration is fixed (see page 31).
• To select variable duration mode, turn the [CONST
DUR] button off.
• To select constant duration mode, press the [CONST
DUR] button, turning it on.
Transition Mode Settings for User
Programmable DME
To create an effect for user programmable DME, it is
necessary to set the transition mode.
: Loop range
User programmable DME in transition
mode
For the transition mode set when creating a keyframe
effect for a user programmable DME pattern, the
following can be used.
Single: single transition mode
Flip tumble (Flip Tumble): flip tumble transition mode
Dual: dual transition mode
Addition
: Loop range
Deletion
: Loop range
Creating and Editing Keyframes
49