Panasonic KX-T336 System Reference Manual page 194

3. Switching of Day/Night Mode
It is assignable to switch Day/Night mode either
automatically at pre-assigned time or manually
by the Operator 1 (Attendant Console or
Extension User) at any time desired.
(Automatic Switching)
The system will switch the day and night modes
at the programmed time automatically each day.
(Manual Switching)
Operator 1 can switch the Day/Night mode at
desired time.
(Supplement)
The following programming items may be
assigned in a different way between day mode
and night mode.
• "System-Class of Service"
Toll Restriction Level (Day)
Toll Restriction Level (Night)
(Refer to Section 9-D-4.01 "Class of
Service (1/2).")
• "Group-Trunk Group"
Incoming Mode (Day)
Incoming Mode (Night)
Intercept Routing (Day)
Intercept Routing (Night)
(Refer to Section 9-E-1.01 "Trunk Group
(1/2).")
• "Extension-Station"
Day Ring
Night Ring
(Refer to Section 9-G-1.02 "Station (2/3).")
8.01 Directed Night Answer
Description
Used to redirect incoming attendant-seeking CO
calls to the designated extension or a group of
extensions (Night Answer Group) automatically in
night mode.
To activate this feature, set "Group-Trunk Group"
Incoming Mode (Night) to FIXED or FLEXIBLE
and "Trunk-CO Line" Night Answer Point to EXT:
xxxx or NAG (Night Answer Group).
Night Answer Group
A single group of extensions (called the Night
Answer Group) can be created to receive calls at
night.
Calls from more than one CO line may arrive at
this group.
The size limit of the group is 32 extensions.
CO1
Night Answer Group
To utilize this feature, program as follows.
1. Assign "Group-Trunk Group" Incoming Mode
(Night) to "FIXED."
2. Assign "Trunk-CO Line" Night Answer Point to
"NAG."
This CO line must belong to the Trunk Group
whose Incoming Mode (Night) is assigned to
FIXED.
3. Assign the DN of the destination extensions
by using NAG command.
3-B-15
(30393)
CO2 CO3