Panasonic KX-T336 System Reference Manual page 266

Programming
Conditions
Dual Console Operation
When two attendant consoles are equipped with the system, one of the
following three types of Incoming Mode can be selected.
Options B and C work only for the incoming outside call routed via a CO
line which belongs to a Trunk Group whose Incoming Mode (Day) is
assigned as "ATT."
A. Load Sharing (Section 3-D-1.01)
Incoming calls are distributed evenly to two attendant consoles so that
they can share the same load. (default)
B. Simultaneous Ringing (Section 3-D-1.02)
An incoming outside call rings at two attendant consoles
simultaneously.
C. Interconsole IRNA (Section 3-D-1.03)
If an incoming outside call ringing at one attendant console is not
answered within a specified time period (Attendant Overflow Time), it
will be automatically transferred to another attendant console.
This selection can be done by entering the WS3 command at Dumb
programming mode.
Refer to "Attendant Incoming Mode" in Section 10-C-53.00 World Select 3
(WS3).
System Programming
"Group-Trunk Group (1/2)",
Incoming Mode (Day)
"World Select 3 (WS3)",
(1)The attendant console is not available to receive a call in:
• Night mode (Section 3-B-8.00)
• ATT-FWD mode (Section 6-A-1.00)
(2)What if all six LOOP keys on the attendant console are in use?
• Heavy Traffic Overflow Transfer to Station (Section 6-G-2.00)
(3)What if an incoming outside call ringing at a LOOP key is not
answered?
• Automatic Redirection If No Answer (Section 6-G-7.00)
(4)Tenant Service
To use two attendant consoles in dual console operation mode, both
consoles should belong to either one of two Tenants.
(5) Operator Assignment
With Dual Console Operation, two attendant consoles must be
programmed as operator 1 and operator 2 for the above operation to
be valid. See Section 3-B-5.00 "Operator" for further information.
3-D-2
(30393)
Reference
VT Dumb
9-E-1.01 10-C-14.00
— 10-C-53.00