Panasonic KX-T336 System Reference Manual page 297

5.02 Station Hunting-Terminal
Description
Station Hunting provides automatic redirection of
incoming calls to an idle member of a hunt group
when the called extension is busy. Idle extensions
are automatically hunted in accordance with the
hunting sequence set in the system program, and
the call is put through to an idle extension.
The hunting sequence is set by "Extension-
Station", Next Hunt Station.
The group formed by this setting is called a
hunting group.
Busy status applies when there are no idle PDN's
for the extension and when the extension is Out of
Service or in fault condition.
Terminal hunting is selected when the last station
in the hunt leaves the Next Hunt Station blank.
Example
DN 100
DN 200
DN 110
DN 120
Hunting Group - Circular
When an incoming call cannot be put through even
after hunting up to the last extension in the hunting
group, busy tone is sent to the calling party.
Programming
System Programming
"Extension-Station (1/3)",
Next Hunt Station
Conditions
An extension can belong to only one hunting
group.
Extensions belonging to a UCD group cannot
belong to hunting groups. Similarly, extensions
belonging to hunting groups cannot belong to UCD
groups.
Incoming call
: Hunting
Reference
VT Dumb
9-G-1.01 10-C-22.00
3-D-21
(21292)
See Section 3-B-7.03 "Uniform Call Distribution
(UCD) Group" for details on UCD groups.
See Section 3-D-2.05, 2.06 "Uniform Call
Distribution (UCD)-without OGM/-with OGM" for
details on the UCD function.
The following calls do not receive the Station
Hunting treatment.
• A call on the ICM button.
• An incoming outside call routed via DIL 1:N
or Private CO feature.
• A call on the SDN button.
When the incoming destination extension is in
any of the following statuses, the operation below
is accomplished instead.
Status
Idle PDN Incoming call processed (caller
hears ringback tone)
FWD setting FWD processing
DND processing
DND setting
Depending on the status of the hunted
extensions, the operation below is accomplished
after hunting starts.
Status
Idle PDN Incoming call processed (caller
hears ringback tone)
Busy Hunting proceeds to next station
FWD setting Hunting proceeds to next station
DND setting Hunting proceeds to next station
The call forwarded to a busy extension/Voice
Mail Port receives the treatment of the Station
Hunting if programmed.
Refer to Section 3-F-10.00 "Voice Processing
System (VPS)" for further information.
A call redirected to another PITS extension by
the Station Hunting feature always rings on a
PDN button on it even if a call is originally routed
on a SCO or GCO button.
Operation
Operation