Paging Group - Panasonic KX-T336 System Reference Manual

7.04 Paging Group

Description
It is possible to execute paging functions in a
group composed of one or more pickup groups.
Such a group is called a "Paging Group."
Up to eight paging groups can be assigned in the
system.
When Tenant Service is employed, the "Group-
ICM/Paging Group" screen sets which tenant the
paging group belongs to.
The "Group-Call Pickup Group" screen sets
which pickup group(s) make up a paging group.
Programming
System Programming
"Group-ICM/Paging Group",
Paging Group-Tenant
"Group-Call Pickup Group",
PAG
Conditions
If tenant service is employed, pickup groups
which can be used to configure a paging group
are limited within the same tenant.
See Section 4-H-1.00 "Paging" for further
information about paging features.
Reference
VT Dumb
9-E-2.00 10-C-16.00
9-E-3.00 10-C-17.00
3-B-13
(70695)
7.05 Trunk Group
Description
To support efficient utilization of trunks, they can
be grouped together (up to 16 groups) if all
trunks in the group perform the same function.
The following six kinds of trunk groups can be
assigned in the system.
The items listed below are set in the "Group-
Trunk Group" screen.
(a) Trunk group type
(b) Trunk group name
(c) Tenant selection
(d) Trunk group direction
(e) Incoming destination (Day)
(f) Incoming destination (Night)
(g) Intercept Routing (Day)
(h) Intercept Routing (Night)
(i) Toll restriction level
(j) Toll restriction table
(k) Dialing plan selection
(l) Disconnect time selection
(m) Pause time selection
(n) Hookswitch flash time selection
(o) DID digit modification table selection
(p) Entry of PBX access code (No restriction)
(q) Entry of PBX access code (Restriction)
(r) Restriction time on CO-CO calls
(s) DIL (I:N) destination
(t) Maximum number of digits after External
Feature Access
(u) CO-TIE Restriction
(v) TIE-CO Restriction
(w) TIE Forced Account Mode
(x) TIE Incoming Delete Digit
(y) TIE Incoming Insert Dial
The "Trunk-CO Line", Trunk Group determines
which trunk group the CO line belongs to.
Programming
System Programming
"Group-Trunk Group"
"Trunk-CO Line", Trunk Group
Conditions
A single CO line cannot belong to more than one
trunk group.
Reference
VT Dumb
9-E-1.01 10-C-14.00
9-E-1.02 10-C-15.00
9-F-1.00 10-C-18.00